System manual Coronis 5MP 104
Figure 87: Windows XP Display Properties Settings Tab for the
5MP2F with DualView enabled
Note: Note:
Note: Note:
Note: The system shown in figure 87 above is a dual-head, single
BarcoMed 5MP2F display controller, no 3
rd
party VGA card
configuration. Your system may look different.
Setting the Resolution of Your CORONIS Display Panel withSetting the Resolution of Your CORONIS Display Panel with
Setting the Resolution of Your CORONIS Display Panel withSetting the Resolution of Your CORONIS Display Panel with
Setting the Resolution of Your CORONIS Display Panel with
DualView DisabledDualView Disabled
DualView DisabledDualView Disabled
DualView Disabled
If you chose to disable DualView when you installed the BarcoMed
Windows XP driver, Windows XP will display a single virtual desktop
that spans across both displays attached to each dual headed
BarcoMed Display Controller.
1. To set the resolution for your CORONIS display(s), right click on an
empty space of the desktop and select
“Properties”“Properties”
“Properties”“Properties”
“Properties”. Select the
“Settings”“Settings”
“Settings”“Settings”
“Settings” tab (see figure 88 on the next page). Now select the
rectrect
rectrect
rect
angleangle
angleangle
angle that represents the BarcoMed Display Controller you
are working with.
SPECIALSPECIAL
SPECIALSPECIAL
SPECIAL
NOTE: NOTE:
NOTE: NOTE:
NOTE: If you are using the VGA capabilities of your
BarcoMed Display Controller, the resolution for that display
controller may still be set to a VGA resolution of “640 x 480”
pixels. If the BarcoMed Display Controller is not running VGA, the
device may not be enabled yet. To enable the device check the
“Extend my Windows desktop into this monitor”
checkboxcheckbox
checkboxcheckbox
checkbox. Do not
click the
“Apply”“Apply”
“Apply”“Apply”
“Apply” button at this time.
2. Click on the
“Advanced”“Advanced”
“Advanced”“Advanced”
“Advanced” Button.
BarcoMed software driver installation
To Next Page
Loading...
Need help?
General
