Barco Coronis 5MP - Barco Display Tab; Introduction

System manual Coronis 5MP 121
BARCO DISPLABARCO DISPLA
BARCO DISPLABARCO DISPLA
BARCO DISPLA
YY
YY
Y
TABTAB
TABTAB
TAB
IntroductionIntroduction
IntroductionIntroduction
Introduction
The BARCO Display Tab is used for gathering information about the
BarcoMed Flat Panel Display(s).
To access the BARCO Display Tab do the following:
1. Open the “Display Properties Control Panel” by right clicking on the
desktop, then select “Properties”.
2. Under Windows NT 4.0, Click on the “BARCO Display Tab” (see
figure 96, below).
Figure 96: BARCO Display Tab under Windows NT 4.0
Under Windows 2000 and Windows XP, click on the “Settings” tab.
Double click on the rectangle that represents the BarcoMed
BarcoMed software driver installation