System manual Coronis 5MP 126
BARCO DPMS Screen Saver OptionsBARCO DPMS Screen Saver Options
BARCO DPMS Screen Saver OptionsBARCO DPMS Screen Saver Options
BARCO DPMS Screen Saver Options
From the “BARCO DPMS Screen Saver Control Panel” you can
change many DPMS screen saver elements simultaneously. The
DPMS screen saver elements in each scheme are work schedule,
work day screen saver, DPMS settings after work day, and many
additional options.
Current SchemeCurrent Scheme
Current SchemeCurrent Scheme
Current Scheme
Lists the three “DEFAULT” schemes which you can use as they are.
Or you can modify them to meet your office’s schedule.
Save AsSave As
Save AsSave As
Save As
Saves your current BARCO DPMS Screen Saver settings. The name
you specify will appear in the Scheme list so you can easily restore
these settings later.
DeleteDelete
DeleteDelete
Delete
Deletes the scheme that is selected in the Scheme box.
Work ScheduleWork Schedule
Work ScheduleWork Schedule
Work Schedule
In this part of the control panel the user may specify the “Begin Work
Day” and “End Work Day” times for each work day. If the system is
not expected to be used, leave both the “Begin Work Day” and the
“End Work Day” times as the same time.
Begin Work DayBegin Work Day
Begin Work DayBegin Work Day
Begin Work Day
The “Begin Work Day” time is the time after which the system is
expected to start being used. During the work day, the screen saver
selected by the user in the “Screen Saver During Work Day” section is
used during user inactivity.
End Work DayEnd Work Day
End Work DayEnd Work Day
End Work Day
The “End Work Day” time is the time after which the system is not
expected to be used any more for that day. After the work day, the
display is set to one of the DPMS states (Stand-By, Suspend, or Off)
by the display controller during user inactivity.
BarcoMed software driver installation
To Next Page
Loading...
Need help?
General
