Barco Coronis 5MP - Hardware Installation; Familiarizing Yourself with the 5 MP2 F; Jumper Location; Using the VGA Capabilities of the Barcomed 5 MP2 F

System manual Coronis 5MP 17
HARDWHARDW
HARDWHARDW
HARDW
ARE INSTARE INST
ARE INSTARE INST
ARE INST
ALLAALLA
ALLAALLA
ALLA
TIONTION
TIONTION
TION
Notice: Notice:
Notice: Notice:
Notice: Wear a protective ESD strap during installation or handling of
the display controller. Electrostatic charges can damage the display
controller.
Familiarizing Yourself With the 5MP2FFamiliarizing Yourself With the 5MP2F
Familiarizing Yourself With the 5MP2FFamiliarizing Yourself With the 5MP2F
Familiarizing Yourself With the 5MP2F
Prior to installing your 5MP2F display controller(s) in your PC please
take a few minutes to familiarize yourself with both the display
controller and the PCI slots in your computer
..
..
.
Figure 1: The 5MP2F
Jumper LocationJumper Location
Jumper LocationJumper Location
Jumper Location
There is one user settable jumper on the BarcoMed 5MP2F. It is used
to enable or disable the VGA capabilites of the display controller.
Using the VGA Capabilities of the BarcoMed 5MP2FUsing the VGA Capabilities of the BarcoMed 5MP2F
Using the VGA Capabilities of the BarcoMed 5MP2FUsing the VGA Capabilities of the BarcoMed 5MP2F
Using the VGA Capabilities of the BarcoMed 5MP2F
Prior to installing the BarcoMed 5MP2F, decide if you are going to use
its on-board VGA capabilities. If you are, check the setting of the
Imaging board installation