Barco Coronis 5MP - Important Installation Considerations; Preparations before Installation; Operating System Requirements; Barcomed Installation Overview

System manual Coronis 5MP 15
PLANNING PLANNING
PLANNING PLANNING
PLANNING
YOUR 5MP2FYOUR 5MP2F
YOUR 5MP2FYOUR 5MP2F
YOUR 5MP2F
INSTINST
INSTINST
INST
ALLAALLA
ALLAALLA
ALLA
TIONTION
TIONTION
TION
ImportImport
ImportImport
Import
ant instant inst
ant instant inst
ant inst
allation considerationsallation considerations
allation considerationsallation considerations
allation considerations
Preparations before installationPreparations before installation
Preparations before installationPreparations before installation
Preparations before installation
1 Make certain all equipment is switched off.
2 In case you use a PCI expansion chassis, please install it following
the guidelines in its User’s Guide.
3 Familiarize yourself with the 5MP2F Display Controller and the
cables used to connect it to the display panel.
4 Read through this guide from beginning to end.
Operating system requirementsOperating system requirements
Operating system requirementsOperating system requirements
Operating system requirements
You must have
WW
WW
W
indows NTindows NT
indows NTindows NT
indows NT
4 4
4 4
4 with at least
Service Pack 4,Service Pack 4,
Service Pack 4,Service Pack 4,
Service Pack 4,
WW
WW
W
indows 2000indows 2000
indows 2000indows 2000
indows 2000 with at least
Service Pack 1Service Pack 1
Service Pack 1Service Pack 1
Service Pack 1 or
WW
WW
W
indows XPindows XP
indows XPindows XP
indows XP installed
on the PC.
BarcoMed installation overviewBarcoMed installation overview
BarcoMed installation overviewBarcoMed installation overview
BarcoMed installation overview
To install the BarcoMed Display Controllers in your system, you have
to follow these steps:
1 Install the display controller(s) in the PC
2 Install and connect the displays to the display controller(s)
3 Install the BarcoMed Display Controller Driver software
Imaging board installation