System manual Coronis 5MP 139
MEDICALMEDICAL
MEDICALMEDICAL
MEDICAL
SOFTW SOFTW
SOFTW SOFTW
SOFTW
ARE INSTARE INST
ARE INSTARE INST
ARE INST
ALLAALLA
ALLAALLA
ALLA
TIONTION
TIONTION
TION
Install MediCal on the PC. Follow the instructions from the MediCal
User Guide.
ImportImport
ImportImport
Import
ant: ant:
ant: ant:
ant: Do not forget you have to have Administrator privileges to
install or uninstall MediCal.
OPTICAL SENSOR CONNECTIONOPTICAL SENSOR CONNECTION
OPTICAL SENSOR CONNECTIONOPTICAL SENSOR CONNECTION
OPTICAL SENSOR CONNECTION
If you are using an X-Rite DTP92 sensor for conformity calibration and
consistency check, connect the sensor to one of the display's
SensorSensor
SensorSensor
Sensor
plugs or to a free PC COM port.
USING MEDICALUSING MEDICAL
USING MEDICALUSING MEDICAL
USING MEDICAL
You can now use MediCal to configure the complete configuration
and set up the Q/A tasks.
Proceed as follows:
1 Start MediCal. If appropriate, you can connect to MediCal
Administrator.
2 Set up the configuration in MediCal by using the
ConfigurationConfiguration
ConfigurationConfiguration
Configuration
SetupSetup
SetupSetup
Setup wizard.
3 If necessary, align the displays' geometry settings.
4 For all the displays in the system, check if the DPMS setting is
turned on. Therefore, right-click on the display icon and select
Properties...Properties...
Properties...Properties...
Properties... from the drop-down menu. Then click on
DetDet
DetDet
Det
ails...ails...
ails...ails...
ails...
Check if the
PowersavePowersave
PowersavePowersave
Powersave option is checked. If not, check it. This is
necessary to use the DPMS possibilities of the imaging board.
5 For all the displays in the system, define (if necessary) and select
a Preset.
6 After selecting the Preset, MediCal starts consistency calibration
automatically.
7 Define the Q/A task schedule.
8 Run the due tasks.
Please refer to the MediCal User Guide for more information.
MediCal software installation and usage
To Next Page
Loading...
