Barco Coronis 5MP - Using the USB Hub; Tilt and Swivel Positioning; Starting up

System manual Coronis 5MP 30
Using the USB hubUsing the USB hub
Using the USB hubUsing the USB hub
Using the USB hub
The USB interface inside the display allows you to connect USB
devices, such as a keyboard, mouse or digital camera, to the display.
The USB interface provides just a USB hub, without any other func-
tionality.
To use the USB hub:To use the USB hub:
To use the USB hub:To use the USB hub:
To use the USB hub:
1 Connect the display’s USB upstream connector (6) to the USB port
of the PC.
2 Connect any USB device to any of the display’s USB downstream
connectors (3) or (7).
TT
TT
T
ilt and swivel positioningilt and swivel positioning
ilt and swivel positioningilt and swivel positioning
ilt and swivel positioning
Adjust the position of the panel for best viewing conditions.
The display foot allows adjusting the horizontal viewing angle, vertical
viewing angle and panel height.
Push the upper side of
the cover onto the foot
Signal cables routed under foot cover
and bound by velcro strips
Connector
compartment
SS
SS
S
tt
tt
t
arting uparting up
arting uparting up
arting up
Proceed as follows:
1 Switch on the signal source (E.g., PC).
2 If necessary, select a suitable resolution or signal format for the
signal source.
Display installation