System manual Coronis 5MP 134
10. Save your preferences by pressing the
“Save “Save
“Save “Save
“Save
As”As”
As”As”
As” button and
entering a new profile name in the
“Save Profile Setting”“Save Profile Setting”
“Save Profile Setting”“Save Profile Setting”
“Save Profile Setting” dialog
box.
11. Apply your new scheme by clicking
“OK”.“OK”.
“OK”.“OK”.
“OK”.
12. Click
“OK”“OK”
“OK”“OK”
“OK” again to close the “Display Properties Control Panel”.
InstInst
InstInst
Inst
alling or Reinstalling or Reinst
alling or Reinstalling or Reinst
alling or Reinst
alling BARCO DPMSalling BARCO DPMS
alling BARCO DPMSalling BARCO DPMS
alling BARCO DPMS
To install or reinstall the BARCO DPMS Screen Saver insert the
CORONIS Software CD in the appropriate device on your computer
and run the BarcoMed Product Install Wizard (please see the section
Software Installation for complete instructions).
SS
SS
S
pecial Note:pecial Note:
pecial Note:pecial Note:
pecial Note: Reinstalling the BARCO DPMS Screen Saver will over
write the DPMS configuration settings and you will need to reconfigure
the DPMS settings on your system.
UninstUninst
UninstUninst
Uninst
alling BARCO DPMSalling BARCO DPMS
alling BARCO DPMSalling BARCO DPMS
alling BARCO DPMS
To remove the BARCO DPMS Screen Saver from your system insert
the CORONIS Software CD in the appropriate device on your
computer, run the BarcoMed Product Install Wizard and follow these
steps.
1. Select only the DPMS Screen Saver on the BarcoMed Product
Install Wizard’s welcome screen and click
“Inst“Inst
“Inst“Inst
“Inst
all”all”
all”all”
all”.
2. Click
“Next”“Next”
“Next”“Next”
“Next” on the Welcome Screen of the BARCO DPMS
InstallShield Wizard to begin the installation (figure 104)
Figure 104
BarcoMed software driver installation
To Next Page
Loading...
