System manual Coronis 5MP 62
snoituloseRdetroppuSfoelbaT
/emaNyalpsiD
forebmuN
sdaeH
tiartroP epacsdnaL
F2PM5
daeHelgniS
daeHlauD
daeHirT
daeHdauQ
zH06@0652x8402
zH05@0652x8402
zH06@0652x6904
zH05@0652x6904
zH06@0652x4416
zH05@0652x4416
zH06@0652x2918
zH05@0652x2918
zH06@8402x0652
zH05@8402x0652
zH06@8402x0215
zH06@8402x0215
zH05@8402x0215
zH06@8402x4416
zH06@2918x0652
zH06@2918x0652
Select
“OK”“OK”
“OK”“OK”
“OK”.
4. Select the
“T“T
“T“T
“T
est”est”
est”est”
est” button and click on
“OK”“OK”
“OK”“OK”
“OK” to test the display. You
will be asked if it displayed correctly. If the test pattern displays
correctly, select
“Y“Y
“Y“Y
“Y
es”es”
es”es”
es”. If not, click on the “List
all Modes all Modes
all Modes all Modes
all Modes” button
and try selecting another mode.
5. In order to apply your changes, you need to click on the
“OK”“OK”
“OK”“OK”
“OK”
button in the “Display Properties” dialogue box, however this
button will not be visible because you are running in VGA mode.
Select
“OK”“OK”
“OK”“OK”
“OK” by pressing
“CTRL” + “Enter”.“CTRL” + “Enter”.
“CTRL” + “Enter”.“CTRL” + “Enter”.
“CTRL” + “Enter”.
6. Windows may be asked if you want to restart your computer, if it
does select
“Y“Y
“Y“Y
“Y
es” es”
es” es”
es” to restart your computer. Even if Windows does
not ask you if you want to restart your computer, you must restart it
and boot normally for your changes to take effect.
7. When you system restarts select the
“NT“NT
“NT“NT
“NT
V V
V V
V
ersion 4.00”ersion 4.00”
ersion 4.00”ersion 4.00”
ersion 4.00” option
(NOT the VGA Mode option). Log in as usual.
If you wish to change the number of CORONIS display panels you are
using, this can be done using the
“BarcoMed Driver “BarcoMed Driver
“BarcoMed Driver “BarcoMed Driver
“BarcoMed Driver
TT
TT
T
ab”ab”
ab”ab”
ab” of the
Windows Display Control Panel.
BarcoMed software driver installation
To Next Page
Loading...
