System manual Coronis 5MP 82
CORONIS display panel supports from the dialog box and click
“OK”“OK”
“OK”“OK”
“OK”.
Note:Note:
Note:Note:
Note: The resolutions shown will be based on the number of
heads the display controller(s) supports.
For example: The BarcoMed Display Controller supports two
CORONIS display panels. If the resolution of each display is
2048x2560x256, Windows 2000 will display the resolution as
4096x2560x256. If necessary you can change the number of
display panels later by using the BarcoMed Driver Tab of the
“Display Properties Control Panel”.
snoituloseRdetroppuSfoelbaT
/emaNyalpsiD
forebmuN
sdaeH
tiartroP epacsdnaL
F2PM5
daeHelgniS
daeHlauD
zH06@0652x8402
zH05@0652x8402
zH06@0652x6904
zH05@0652x6904
zH06@8402x0652
zH05@8402x0652
zH06@8402x0215
zH05@8402x0215
Click
“OK”“OK”
“OK”“OK”
“OK” on the bottom of the Adapter Control Panel. If the
“OK”“OK”
“OK”“OK”
“OK” button on the bottom of the Adapter Control Panel is not
visible, press the
“T “T
“T “T
“T
ab” ab”
ab” ab”
ab” key once and then
“Enter” “Enter”
“Enter” “Enter”
“Enter” to select
“OK”“OK”
“OK”“OK”
“OK”.
4. Click
“OK”“OK”
“OK”“OK”
“OK” in the “Windows will now apply your new desktop
settings” dialog box. Your high resolution display(s) should now
synchronize and display the Windows desktop.
5. Click
“Y“Y
“Y“Y
“Y
es” es”
es” es”
es” when asked, “Your desktop has been reconfigured.
Do you want to keep these settings?”
Repeat steps 1 – 5 for each BarcoMed Display Controller installed
in your system.
BarcoMed software driver installation
To Next Page
Loading...
