Barco Coronis 5MP - Page 115

System manual Coronis 5MP 116
To access the BarcoMed Hardware Tab do the following:
1. Open the “Display Properties Control Panel” by right clicking on the
desktop, then select “Properties”.
2. Under Windows NT 4.0, Click on the “BarcoMed Hardware Tab”
(see figure 94, below).
Under Windows 2000 and Windows XP, click on the “Settings” tab.
Double click on the rectangle that represents the BarcoMed
Display Controller to bring up its property page. Click on the
“BarcoMed Hardware Tab” (see figure 95, on the next page).
Figure 94: BarcoMed Hardware Tab
under Windows NT 4.0
BarcoMed software driver installation