System manual Coronis 5MP 132
3. Click on the
“Settings”“Settings”
“Settings”“Settings”
“Settings” button. The “BARCO DPMS Screen Saver
Control Panel” will open (see figure 102).
Figure 102: BARCO DPMS Settings Control Panel
4. Use the default schemes by selecting one of the three default
schemes. Click
“OK”“OK”
“OK”“OK”
“OK”. Then Click
“OK”“OK”
“OK”“OK”
“OK” again.
Note: Note:
Note: Note:
Note: If you make any changes to any of the settings of one of the
three default schemes, the Current Scheme field will blank and you
MUST SAVE your changes by clicking on the
“Save “Save
“Save “Save
“Save
As ...”As ...”
As ...”As ...”
As ...” button.
When you click on the
“Save “Save
“Save “Save
“Save
As ...”As ...”
As ...”As ...”
As ...” button, the name of the last
scheme you used will be automatically displayed, you can then
choose to use that scheme name or enter a new name. If you
enter a name other than one of the three default scheme names,
the program will ask you if you wish to save the scheme as a
DEFAULT scheme (see figure 103 on the next page). Click
“Y“Y
“Y“Y
“Y
es”es”
es”es”
es”
to save the settings scheme as a DEFAULT scheme, click
“No”“No”
“No”“No”
“No” to
save the scheme as a PRIVATE scheme. After you have saved
the scheme, then click OK and the new scheme will be in effect.
BarcoMed software driver installation
To Next Page
Loading...
