System manual Coronis 5MP 48
Figure 5
The BarcoMed Product Installation Wizard will advise you when it
has successfully installed the new version of the Microsoft Installer
(figure 6).. Click
“OK”“OK”
“OK”“OK”
“OK” to continue.
Figure 6
The BarcoMed Product Installation Wizard may prompt you to
restart your system. If it does, you must restart your system in
order for the updated version of the Microsoft Installer to be
effective and to be able to install the software on your BarcoMed
Software CD. Click
“Y“Y
“Y“Y
“Y
es”es”
es”es”
es” to restart your system. When your
system restarts log in using an account with administrator
privileges. The BarcoMed Product Installation Wizard will restart
automatically.
If the BarcoMed Product Installation Wizard doesn’t prompt you to
restart your system, it will continue to the Welcome Screen.
4. By default all the software on the BarcoMed Software CD will be
selected (figure 7). For the initial installation we recommend that
you install all of the software. If you do not want to install a
particular BarcoMed Software product, deselect it by clearing the
checkbox next to it. When you have finished selecting the
BarcoMed Software you wish to install, click
“Inst“Inst
“Inst“Inst
“Inst
all”all”
all”all”
all” on the
Wizard’s Welcome Screen to continue or
“Cancel” “Cancel”
“Cancel” “Cancel”
“Cancel” to exit the
wizard.
If you click
“Inst“Inst
“Inst“Inst
“Inst
all” all”
all” all”
all” the wizard will begin installing the
selected software. The wizard will install the software in the
order listed on the Wizard’s Welcome Screen.
BarcoMed software driver installation
To Next Page
Loading...
