System manual Coronis 5MP 93
Figure 69
13. The screen shown in figure 70 displays the device(s) that will be
installed. If you want to change your selection, click BACK and
you will see the previous screen. To begin installation, click
“Next” “Next”
“Next” “Next”
“Next” to continue. If you want to end the installation without
installing the driver, click
“Cancel” “Cancel”
“Cancel” “Cancel”
“Cancel” and the Wizard will exit.
SS
SS
S
pecial Note:pecial Note:
pecial Note:pecial Note:
pecial Note: Once you click
“Next”, “Next”,
“Next”, “Next”,
“Next”, you cannot cancel the driver
installation.
Figure 70
14. Prior to beginning the installation the BarcoMed Driver Install
Wizard will warn you that while the driver is being installed your
display may flicker (figure 71). Click
“OK”“OK”
“OK”“OK”
“OK” to continue.
BarcoMed software driver installation
To Next Page
Loading...
