11. Maintenance
11.4 Replacement of the dust filter on the bottom side
Necessary parts
• New HEPA dust filter for the bottom side.
• 2.5 mm Allen key.
How to replace the HEPA dust filter on the bottom side of the projector ?
1. Remov e the side cover of the projector.
2. Release (not remove) the two wedge lock screws (A) using a 2.5 m m Allen key a s illustrated.
A
A
Image 11-3
3. Remov e the filter (F) on the bottom side by pulling out the filter holder ( H) as illustrated.
F
H
H
Image 11-4
4. Place a new HEPA dust filter in the filter holder.
5. Reinstall the filter holder containing the new
HEPA filter.
6. Fasten the two wedge lock screws (A) using a 2.5 mm Allen key as illustrated.
A
A
Image 11-5
7. Reinstall the side cover of the projector.
CAUTION: Never install a used HEPA filter. Always install a new HEPA filter.
96 R59770091 DP-1500 06/01/2009
To Next Page
Loading...
