13. Removal and installation of projector covers
13.11 Installation of the side cover
Necessary tools
7mmflat screw driver.
How to install the side cover of the projector?
1. Check if the bottom and top filters a re present.
2. Look through the sm all window, which is provided on the security c over of the light processor and check the pr essure indicated
on the internal m anometer of the liquid cooling circuit. Th is pressure s hould be be tween 0,5 and 1 bar. If the pressure is out of
range, inform the responsible and qualified technician, so he m ay take necessary corrective action.
Image 13-21
3. Install the s ide cover of the projector doing the following:
a) B ring the side cover towards its final position (A),
b) then ge ntly push t he loc king studs of the top corners (B) into their receivers,
c) then gently pus h the locking studs of the bottom c orners (C) into their receivers.
B
B
C
C
A
Image 13-22
4. Secure the side cover by locking t he captive screw in the middle at the bottom of the side cover.
Image 13-23
134 R59770091 DP-1500 06/01/2009
To Next Page
Loading...
