6. Lamp & lamp house
6.6 Resetting the lamp parameters
CAUTION: The “LAMP INFO” parameters which are stored on a chip MUST be updated after each installation
of an xenon bulb lamp inside the lamp house. Neglecting this update will result in poor performance and short
life time of the xenon bulb lamp.
How to reset the lamp parameters?
1. Start up the pr ojector but do not ignite the lamp.
2. Go via the Communicator touch panel to the m enu “Installation”>“Lamp”>“Lamp information”.
3. While the Lamp information window is display ed, tip on Reset (1 ).
A reset message is displayed (2).
4. Fill out the article number of the new lamp (3a)
Or,
click on Select (3b) to display a list of pos sible article numbe rs (4). Select a article number (5) and click OK (6).
The software w ill check if the entered article number is a valid number (7).
5. Fill out the serial num ber of the lamp (8).
6. Click Reset (9).
Image 6-21
Reset lamp info
CAUTION: For more information about using the Communicator touch panel consult the user’s guide of the
communicator touch panel.
R59770091 DP-1500 06/01/2009 59
To Next Page
Loading...
