Barco DP-1500 - Preparing for Convergence Adjustment

12. Servicing
12.3.2 Preparing for convergence adjustment
Necessary tools
Flat blade screwdriver 7x150.
How to set up the projector for convergence adjustment?
1. Remov e all side co vers and top cover of the projector.
2. Open the sealed compa rtment of the Light Processor. See page 130.
3. Remov e the convergence cover plate in the top plate as follow:
a) loos en both captive screws ( reference 1).
b) s lide the c over plate forward until it becomes free from the top plate.
c) take off the cover plate.
1
Image 12-7
4. Reinstall the lens and s tart up the projector.
5. Use the Communicator software to activate the converg ence test pattern.
4
1
2
5
3
6
Image 12-8
106 R59770091 DP-1500 06/01/2009