13. Removal and installation of projector covers
13.13 Installation of the input cover
Necessary tools
7mmflat screw driver.
How to install the input cover of the projector?
1. Install the input cover of the p rojector doing the following:
a) B ring the input cover towards its final p osition (A),
b) then gently push the locking s tud a t the right top corner (B) into its receiver,
c) then gently pus h the locking stud at the r ight bottom corner (C) into its receiver.
A
C
B
Image 13-26
2. Secure the input c over by locking the two captive screws at the left side of the input cover.
Image 13-27
136 R59770091 DP-1500 06/01/2009
To Next Page
Loading...
