Barco DP-1500 - 13 Removal and Installation of Projector Covers

13. Removal and installation of projector covers
13. REMOVAL AND INSTALLATION OF PROJECTOR
COVERS
About this chapter
Most mainten ance and servicing procedures deman d removing one or more of the projec tor covers to gain access to the parts to
maintain or to service. To avoid redundancy, all p rocedures about co ver removing or installing are grouped together in this chapter.
The maintenance and servicing procedures also refer to this chapter if required. Th e p rocedur
es in this chapter describe, with
detailed s tep by step actions and illustrations, how to remove or install the projector c overs . Note that some covers may only be
removed by qualified service personnel, see remarks above each procedure.
WARNING: Always switch off the projector and unplug the power cord before removing one of the covers,
unless otherwise stated.
Overview
• Removal of the lamp c over
• Removal of the input cover
• Removal of the front cover
• Removal of the side cover
• Removal of the rear cover
• Removal of the top cover
• Open the sealed co mpartme nt
• Close the sealed c ompa rtment
• Installation of the top cover
• Installation of the rea r cover
• Installation of the side cover
• Installation of the front cover
• Installation of the input cove r
• Installation of the lam p cover
R59770091 DP-1500 06/01/2009
123