5. Lenses & lens holder
5.5 Lens installation
How to install a lens into the projector lens holder ?
1. Remov e the foam rubber in the opening of the lens holder if not removed yet.
2. Take the lens ass embly out of its packing material and rem ove the lens caps on both sides.
3. Place th e lens holder in the “u nlocked” position by moving the lens lock handle (A) towards the lens power supply sock et (B ) as
illustrated.
B
A
Image 5-6
4. Ensure that the lens holder stands in the On-Axis position (horizontal and vertical mid position).
Note: The lens holder is placed default in the On-Axis position at factory.
5. Gently insert the lens in such a w ay that the lens connector matches the so cket (B).
Image 5-7
6. Insert the lens until the connector seats into the socket.
Warning: Do not release the lens yet, as the lens may fall out of the lens holder.
7. Secure the lens in the lens holder
by sliding the lens lock handle into the “locked” position, wh ich is away from the lens power
supply socket. Ensure the lens touches the front plate of the lens holder.
38
R59770091 DP-1500 06/01/2009
To Next Page
Loading...
