12. Servicing
4. Slightly turn the red colored control knob num ber 3 until the red pattern in the upper right of the pr ojected image converges with
the blue pattern.
3
6
Image 12-12
5. Repeat step 3 and 4 until coincidence is obtained of the red pattern in the lower left and upper right of the projected image.
6. Repeat from step 2 until full coincidence is obtained of the red pattern in the center, lower left and upper right of the projected
image.
7. Carefully sec ure the position of the DMD assembly by tightening the four convergence lock screws (reference 7 of image 12-9)
of the red channe l. Fa sten the screws c rosswise with small adjus
tments to each screw. Use a 2,5 m m Allen wr ench.
108
R59770091 DP-1500 06/01/2009
To Next Page
Loading...
