12. Servicing
4. Slightly turn the green colored control knob number 6 until the green pattern in the upper right of the projected image converges
with the b lue pattern.
3
6
Image 12-16
5. Repeat step 3 and 4 until coincidence is obtained of the green pattern in the lower left and upper right of the projected image.
6. Repeat from step 2 until full coincidence is obtained of the green pattern in the center, lower left and upper right of the projected
image.
7. Carefully secure the position of the DMD ass embly by tightening the four convergence lock screws (reference 8 of imag e 12-13)
of the green channel. Fasten the screws crosswise with small adj
ustments to each screw. Use a 2,5 mm Allen wrench.
8. Close the sealed com partment and reinstall all covers of the projector.
110
R59770091 DP-1500 06/01/2009
To Next Page
Loading...
