Revision History
232 Basler pilot
AW00015116000 17 June 2009 Added information (drawings inclusive) about the 90° head housing variant
in Section 1 on page 1.
The designations of the Kodak sensors were indicated more specifically by
adding "M" and "CM" for mono and color sensors, respectively, in
Section 1.2 on page 2.
Added maximum sensor tilt angles for the piA2400-17gm/gc in Figure 12 on
page 16 and Figure 14 on page 19.
Indicated the relevance of spectral response curves for the piA2400-17gm/
gc in Section 1.3 on page 8 and Section 1.4 on page 11.
Section 2 on page 27, and Section 3 on page 29, and have been revised to
reflect that the pylon driver package can now be downloaded from the
website.
Updated the minimum allowed exposure times in Section 8.4 on page 91.
Added the digital shift feature in Section 11.4 on page 156.
Corrected the indications of x offset and y offset in Figure 44 in Section 11.6
on page 163 and in Figure 51 in Section 11.12.1.2 on page 182.
Added the reverse X feature in Section 11.8 on page 170.
Removed the statement that auto functions have no effect on frame rate in
Section 11.12.1 on page 180 and added a note that frame rate may be
affected if exposure auto is used in Section 11.12.3 on page 189.
Added a reference to the reverse X feature in Section 11.12.1.2 on
page 182.
Replaced "Auto Gain Raw" by the correct "Gain Raw (All)" parameter name
in Section 11.12.2 on page 187.
Replaced "Auto Exposure Time Abs" by the correct "Exposure Time Abs"
parameter name in Section 11.12.3 on page 189.
Added the auto function profile feature in Section 11.12.4 on page 191 and
adjusted Section 11.12.2 on page 187 and Section 11.12.3 on page 189
accordingly.‘
Added the trigger delay feature in Section 11.15 on page 197.
Added the acquisition status feature in Section 11.16 on page 198 and
added a reference in Section 8.2.3 on page 82.
Added descriptions about resetting the frame counter and about relating
frame and trigger input counter in Section 11.17.3 on page 202.
Corrected the maximum value for the frame counter in Section 11.17.3 on
page 202.
Added the trigger input counter feature in Section 11.17.5 on page 206.
Added the high gain and auto functions factory setups and the standard
factory setup (formerly the "default set") in Section 11.21 on page 220.
Removed the statement that settings for frame transmission delay and inter
packet delay are not saved in the user sets in Section 11.21 on page 220.
Added Section 12.1 on page 225 describing how to obtain an RMA number.
Doc. ID Number Date Changes
To Next Page
Loading...
