10 Disassembly and disposal
10.1 Decommissioning
Shut off the unit as follows:
1.
Disconnect the unit from the power supply or any energy supply.
2.
Depressurize the unit.
3.
Disconnect pneumatic connections.
4.
Drain condensate and collect it.
5.
If necessary remove the filter cartridges.
6.
Drain oil and collect it.
Dispose the unit, dismantled components and the collected substances such as ail
and condensate according to
Chapter 10.2, Page 121.
10.2 Dispose the unit
To exclude health and enviromental damage when disposing the unit, assemblies
and equipment, observe the following instructions.
NOTICE
Environmental damage in case of improper disposal!
Electrical waste, electronic components, lubricants and other auxiliary materials
are subject to the provisions regarding the treatment of special waste.
Ensure that these materials are only disposed of by licensed specialised compa-
nies.
1.
Be mindful of the local regulations.
2.
Before disassembly, switch of the unit properly according to Chapter 10.1,
Page 121 .
3.
Ensure that the disassembled components of the unit are, in accordance with
the applicable local regulations, recycled or disposed of in an orderly fashion.
•
Metallic components to be turned into scrap metal.
•
Electrical and electronic components to be turned into electrical waste.
•
Dispose chemicals according to the manufacturer´s instructions in the safety
data sheet.
•
Plastic parts, cardboard and paper should be recycled.
•
Dispose of the remaining components after sorting them with respect to the
nature of the materials.
OPERATING MANUAL Disassembly and disposal | 10
28.08.2019
A_002_en
121/150
To Next Page
Loading...
