Danger due to gas, dust and smoke
•
When working with smothering gases, you must monitor the oxygen concen-
tration in the room using a mobile gas measuring device.
•
When working in confined spaces, ensure adequate ventilation and follow ex-
isting national regulations where applicable.
•
Execute welding, flame-cutting and grinding work on and next to the machine
only when the work has been specifically approved.
•
Before welding, flame-cutting and grinding, clean the machine and surround-
ings of dust and flammable materials and ensure adequate ventilation to avoid
a danger of explosion.
Danger due to oil, grease and other chemical substances
•
When handling oils, grease and other chemical substances, observe the safety
regulations applicable to the product.
Danger due to noise
•
The noise protection equipment on the machine must be in the protection po-
sition when the equipment is running.
•
Wear the specified personal hearing protection.
2.4.2 Safety instructions regarding transport and loading work
Carry out the following measures to ensure safe transport:
•
Machines, individual parts and larger components must be securely fastened
to lifting tackles.
•
Do not stand or work under suspended loads.
•
Use only experienced persons for slinging the loads and instruct the crane
drivers. The instructor must be in view of the operator or in voice contact with
him.
•
Use only suitable lifting tackles, load carrying equipment and transport vehi-
cles with adequate carrying capacity.
•
Secure the load in a reliable manner. Use suitable lashing points.
•
Fit transport securing devices to the machine for transporting if necessary. Fix
the relevant sign. Remove the transport securing devices before commission-
ing/recommissioning.
•
Re-fit and secure the parts removed for transport purposes before recommis-
sioning.
•
Isolate the machine from all external energy supplies, even if the location to
be changed is over a small distance. Connect the machine properly to the
mains before recommissioning.
OPERATING MANUAL For your safety | 2
28.08.2019
A_002_en
19/150
To Next Page
Loading...
