Filling oil
NOTICE
Risk of damage when changing the oil type!
Before changing the oil type note the chapter "Oil change".
Suitable BAUER compressor oil is available, seeChapter 9.3.4 Lubrication oil,
Page 86 . Refer to technical data for the required quantity.
1.
Open oil filler spigot.
2.
Fill fresh oil until the oil reaches the maximum-mark on the oil level gauge.
- Or -
If a new oil (as opposed to the type that has been used so far) is supposed to
be used: Change the oil.
3.
Close oil filler spigot.
4.
Use the oil level gauge to check the oil level.
Ä
The oil level must be between the two markings on the oil level gauge.
5.
Wait for a few minutes, then start up the unit when the oil level is as it should
be.
9.4.3
Changing the oil type
Oil is drained.
Oil filter is replaced.
NOTICE
Damage to unit due to improper change of oil type!
Adhere to the following instructions when switching over to another oil type.
1.
Check the valves, coolers, separators and lines for deposits.
Are deposits present in valves, coolers, separators or lines?
Remove deposits, or replace valves, coolers, separators and lines.
2.
Fill compressor with new oil.
3.
After 100 operating hours: Replace oil filter and check the overall contamina-
tion degree of the compressor oil. Change the oil if it is severely contamina-
ted.
9 | Maintenance OPERATING MANUAL
94/150
A_002_en
28.08.2019
To Next Page
Loading...
