Installation of unit outdoors
DANGER
Danger of poisoning!
Exhaust gases could get drawn in if there is no wind or swirling winds. This may
lead to fatal concentrations of CO in the cylinder.
Do not fill cylinders if there is a possibility that exhaust gases could be drawn
in.
Check the concentration of CO in the compressed air using a suitable gas
measuring instrument.
NOTICE
Material damage caused by seawater and corrosion!
If operating in salt-containing atmospheres, the compressor must be sprayed
with a corrosion-protection agent.
Units with electric motors must always be operated and stored indoors.
Units with petrol engines must be stored indoors after use.
1.
Make sure that there are no vehicles with their engines running close to the
intake section.
2.
Install the unit in a horizontal position.
Fig. 12 Install the extraction unit
3.
Use the intake hose with pre-filter, or intake hose with intake filter to increase
the distance between the exhaust gases and the air intake.
OPERATING MANUAL Installation | 6
28.08.2019
A_002_en
57/150
To Next Page
Loading...
