Configuring Your Router
WAN – EWAN Connection Setup (Bridging)
BEC 8920AC User Manual
EWAN Internet Protocol - Bridging
VCP/VPI (For ATM Mode only): Enter the VCI/VPI from you Internet Service Provider (ISP). This
information should be provided by your ISP, please consult them for more information.
Encapsulation Mode (For ATM Mode only): Select the encapsulation mode, LLC/SNAP-BRIDGING,
or VC/MUX. This information should be provided by your ISP, please consult them for more
information.
Description: User-defined description for the connection, commonly for friendly use.
802.1P Priority: The parameter indicates the frame priority level from 0 (lowest) to 7 (highest), which
can be used to prioritize different classes of traffic (voice, video, data, etc). Enter the priority
identification, tagged: 0-1, untagged: -1.
802.1Q VLAN ID: It is a parameter to specify the VLAN which the frame belongs. Enter the VLAN ID
identification, tagged: 0-4094, untagged: -1.
Allow as IGMP Multicast Source (for IPv4): Enable to deliver multicast packets from a specific
source to the interested clients. (Only available in IGMPv3)
Allow as MLD Multicast Source (for IPv6): Enable to deliver multicast packets from a specific
source to the interested clients. . (Only available in IGMPv3)
To Next Page
Loading...
