121
Sun protection
Drives
Information
PSF(+) drives with electronic limit
switching detect and program the
Retract limit position automatically if
a permanent stop exists.
If no stop exists, a limit switch-off
point is programmed.
PSF drives
PSF drives are used to operate
screens, awnings and conservatory
shading.
PSF+ drives
PSF+ drives are used to operate
cassette awnings that require a
higher closing torque. The cassette
is always closed completely.
Programming the master
transmitter
Set the drive to programming mode
for 3 minutes by switching the power
on or by setting the radio switch
to the position . Then press the
programming button on the master
transmitter until the drive clicks
twice
(3 seconds when installing
new drives, 10 seconds to overwrite
a previously programmed master
transmitter).
Correcting the direction of
rotation
If the drive is rotating in the wrong di-
rection, reverse the direction switch
on the drive.
Attention: The direction of rota-
tion can only be changed as long
as no limit positions have been
programmed.
2x click
To Next Page
Loading...
