Becker M User Manual

129
Sun protection Drives
Information
Stop behaviour
The C12 can be switched between
increased and reduced stop behav-
iour.
Autoinstall
The C12 can automatically detect
and program the optimum maximum
Extend limit position for articulat-
ed-arm and cassette awnings via
the Autoinstall function.
Fabric stretching function
A programmable fabric stretching
function ensures the fabric is pulled
taut after extending to the lower limit
position.
Fabric untensioning
When the fabric untensioning is
active, the drive moves slightly in
the Extend direction once it reaches
the Retract limit position in order to
relieve the strain on the fabric.
Click
Increased stop behaviour with cassette awnings
Reduced stop behaviour with open awnings, screens,
etc.
Programming the master
transmitter
Set the drive to programming mode
for 3 minutes by switching the power
on or by setting the radio switch
to the position . Then press the
programming button on the master
transmitter until the drive clicks
twice (3 seconds when installing
new drives, 10 seconds to overwrite
a previously programmed master
transmitter).
Correcting the direction of
rotation
Via the switch on the drive: If the
direction of rotation is incorrect,
change over the direction switch at
the drive (a limit position must not
have been programmed yet).
Via the master transmitter: Press the
programming button until the drive
clicks once. Then press the pro-
gramming button, RETRACT button
and EXTEND button until the drive
clicks three times.
2x click
1x click
3x click

Becker M Specifications

General

Brand	Becker
Model	M
Category	DC Drives
Language	English