Becker M User Manual

135
Sun protection Drives
Information
Obstacle detection
In order to avoid uncontrolled
unwinding of the shading solution,
obstructions in the DOWN direction
are detected (such as wind load).
For the sensitive obstruction de-
tection to become active, the drive
adapter must be fitted with obstruc-
tion detection on the drive and the
shading solution must have a heavy
end strip.
Drive adapter with
obstacle detection
Drive adapter
Fabric untensioning
When the fabric untensioning is active,
the drive moves slightly downwards
once it reaches the Retract limit posi-
tion in order to relieve the strain on the
fabric.
Click
Programming the master
transmitter
Set the drive to programming mode
for 3 minutes by switching the power
on or by setting the radio switch
to the position . Then press the
programming button on the master
transmitter until the drive clicks
twice (3 seconds when installing
new drives, 10 seconds to overwrite
a previously programmed master
transmitter).
Correcting the direction of
rotation
Via the switch on the drive: If the
direction of rotation is incorrect,
change over the direction switch at
the drive (a limit position must not
have been programmed yet).
Via the master transmitter: Press the
programming button until the drive
clicks once. Then press the pro-
gramming button, RETRACT button
and EXTEND button until the drive
clicks three times.
2x click
1x click 3x click

Becker M Specifications

General

Brand	Becker
Model	M
Category	DC Drives
Language	English