Becker M User Manual

150
Centronic radio technology
Programming the master
transmitter
Switch the mains voltage at the radio
receiver (radio drive or external Cen-
tronic radio receiver) back on (power
on) or switch the radio switch of the
radio drive to the
position or press
the radio programming button of the
external Centronic radio receiver .
Then press the programming button
for 3 seconds
until the radio drive
clicks twice or the external radio
receiver acknowledges the pro-
gramming by shifting briefly twice.
Programming the transmitter
Overwriting the master
transmitter
Programming a new master trans-
mitter overwrites the old master
transmitter. All other parameters pro-
grammed in the receiver are retained.
Switch the mains voltage at the radio
receiver (radio drive or external Cen-
tronic radio receiver) back on (power
on) or switch the radio switch of the
radio drive to the position or press
the radio programming button of the
external Centronic radio receiver .
Then press the programming but-
ton on the master transmitter to be
reprogrammed for 10 seconds
until the radio drive clicks twice
or
the external radio receiver acknowl-
edges the programming by shifting
briefly twice.
1x click
2x click

Becker M Specifications

General

Brand	Becker
Model	M
Category	DC Drives
Language	English