Becker M - Page 159

159
Radio technology
Deleting all receivers
in the hand-held
transmitter that are
not responding
"Cleaning up" the memory in
the hand-held transmitter
You can delete specific receivers
that are no longer responding but
are still registered in the memory of
the hand-held transmitter.
Make sure that you are within range
of all responding receivers. Press
the master button on the hand-held
transmitter
until the manual/auto
button flashes .
Press the programming button
and keep it pressed until the LED on
the hand-held transmitter lights up
yellow .
Then press the programming button
and keep it pressed until the LED
flashes yellow .
Then press the programming button
and keep it pressed until the LED
flashes yellow again then flashes
green .
Repeater mode
Activating the drive as radio
signal amplifier
Press the master button on an already
programmed transmitter repeatedly
until the required drive clicks once
. Then press the programming and
manual/auto buttons on the same
transmitter until the drive clicks
once .
Deactivating the drive as
radio signal amplifier
Perform the steps for activation
described above until the drive
clicks twice.
1x click
1x click