24
Setting the limit positions using the programming unit
1. Programming the upper limit
position
First, run the roller shutter towards
the upper limit position until the drive
switches off automatically.
Note: For safety reasons, the drive
uses less force when opening the
shutter for the first time (installation
run). If the force is borderline, the drive
may stop before reaching the upper
limit position. After reversing a short
way, the drive is started again until it
reaches the upper limit position.
2. Programming the lower limit
position
Run the roller shutter downwards until
the drive switches off automatically due
to the back-pressure of the springs or
blocking by the anti-lifting device .
RO+ (E02) drives
To Next Page
Loading...
Need help?
General