Becker M User Manual

63
Roller shutter Drives
Information
B01 drives with electronic limit switching
detect and program the limit positions
automatically if stops exist. If no stops
exist, limit switch points are programmed.
In order for the drive to detect the
upper limit position correctly, a defined
stop must be present (angled strip or
mechanical stop).
Installation with anti-lifting devices
The anti-lifting device must be securely
engaged and be pressing the roller shutter
onto the window sill.
Programming the transmitter
Set the drive to programming mode for
3 minutes by switching the power on
or by setting the radio switch to the
position . Then press the programming
button on the required master transmit-
ter until the drive clicks twice .
Correcting the direction of rotation
Via the switch on the drive: If the
direction of rotation is incorrect, change
over the direction switch at the drive
(a limit position must not have been
programmed yet).
Via the transmitter: Press the master
button
under the battery
compartment lid repeatedly until the
drive clicks once . Then press the
programming button, UP button and
DOWN button until the drive clicks
three times .
2x click
1x click
3x click

Becker M Specifications

General

Brand	Becker
Model	M
Category	DC Drives
Language	English