Becker M User Manual

64
Setting the limit positions
First, put the transmitter into
master mode.
Press the master button under the battery
compartment lid repeatedly until the drive
clicks once.
1. Programming the upper limit
position (in master mode)
To upper stop
Run the roller shutter towards the
upper stop until the drive stops
automatically.
To upper point
Run the roller shutters to the
desired upper position. Then press
the programming button and the UP
button until the drive clicks once.
2. Programming the lower limit
position (in master mode)
To lower stop
Run the roller shutter down until the
drive switches off automatically (the
drive adapter for obstacle detection
must be used for the installation with
springs).
To lower point
Run the roller shutters to the desired
position. Then press the programming
button and the DOWN button until the
drive clicks once.
3. Deleting the lower limit
positions (in master mode)
Press the programming button and the
STOP button until the drive clicks twice.
If the roller shutter is situated between
the limit positions, both limit positions
are deleted in the procedure. If the
roller shutter is situated in one of the limit
positions, only this position will be
deleted.
B01 drives
1x click
2x click

Becker M Specifications

General

Brand	Becker
Model	M
Category	DC Drives
Language	English