Becker M - Page 98

98
Setting the stop behaviour
On delivery, the 35 diameter drive
types have a reduced stop behav-
iour, and the 45 diameter and 58 di-
ameter drive types have an increased
stop behaviour. The stop behaviour
can only be changed during the first
3 runs towards the upper stop.
Switching on reduced stop
behaviour
Move the shading solution up
and also press the programming
button before it reaches the upper
limit position . Keep holding both
buttons pressed until the shading
solution confirms the changeover
by extending and retracting once
.
Switching on increased stop
behaviour
Repeat the procedure under
until the drive confirms the
changeover by extending and
retracting twice
.
Setting the special function fabric untensioning
1. Activating/deactivating the
fabric untensioning function
On delivery, the fabric untensioning
function is deactivated on drive types
with a diameter of 35 mm, and is ac-
tivated on drive types with diameters
of 45 mm and 58 mm.
Run the shading solution towards
the upper stop .
Press the programming button
until the drive confirms activation or
deactivation of the fabric untension-
ing .
E12 drives