Beech Beechcraft Bonanza V35 - Introduction

BEECH CRAFT Bonanza Section VIII
V35, V35A & V35B thru D-9947 Handling, Serv- Maint
INTRODUCTION
The purpose of this section is to outline the requirements
for maintaining the airplane in a condition equal to that of
its original manufacture. This information sets the time
frequency intervals at which the airplane should be taken
to a BEECHCRAFT Aero or Aviation Center or Interna-
tional Distributor or Dealer for periodic servicing or
preventive maintenance.
The Federal Aviation Regulations place the responsibility
for the maintenance of this airplane on the owner and
operator of the airplane who must ensure that all
maintenance is done by qualified mechanics in conformity
with all airworthiness requirements established for this
airplane.
All limits, procedures, safety practices, time limits,
servicing and maintenance requirements contained in this
handbook are considered mandatory.
Authorized BEECHCRAFT Aero or Aviation Centers and
International Distributors or Dealers will have
recommended modification, service, and operating
procedures issued by both FAA and Beech Aircraft
Corporation, designed to get maximum utility and safety
from the airplane.
If there is a question concerning the care of the airplane, it
is important to include the airplane serial number in any
correspondence. The V35 serial number appears on the
model designation placard attached to the underside of the
fuselage just forward of the tiedown. The designation
placard on V35A and V358 models is attached to the side
of the fuselage under the baggage door.
January 1982 8-5