Beech Beechcraft Bonanza V35 - Before Starting

Section IV
Normal Procedures
BEECHCRAFT Bonanza
V35, V36A & V35B thru D-9947
9. RIGHT LANDING GEAR:
a. Fuel Vent - CHECK
b. Fuel Sump - DRAIN
c. Wheel Well Door, Tire and Strut - CHECK
10. RIGHT WING LEADING EDGE:
a. Cabin Air Intake - CHECK
b. Tie Down and Chocks - REMOVE
c. Fuel Tank - CHECK QUANTITY; Filler Cap -
SECURE
11. RIGHT WING TRAILING EDGE:
a. Position Light - CHECK
b. Wing Tip - CHECK
c. Aileron - CHECK
d. Flap - CHECK
CAUTION
NEVER TAXI IF ANY STRUT IS FLAT.
BEFORE STARTING
1. Seats - POSITION AND LOCK; Seat Backs - UPRIGHT
2. Seat Belts and Shoulder Harnesses - FASTEN
3. Parking Brake - SET
4. All Avionics - OFF
5. Circuit Breakers - IN
6. Landing Gear Handle- DOWN; Safety System - CHECK
(If installed)
7. Flaps - UP
8. Cowl Flaps - OPEN
9. Light Switches - As required
10. Electric Elevator Trim Switch - OFF (If installed)
4-6
January 1982