Section VIII BEECHCRAFT Bonanza
Handling, Serv- Maint V35, V35A & V35B thru D-9947
operation and replaced as necessary. The in-line filter is
located between the pressure regulator and the in-
struments. This filter should be changed every 300 hours
of operation.
INDUCTION AIR FILTER
This filter should be inspected for foreign matter at least
once during each 5O-hour operating period. In adverse
climatic conditions, or if the airplane is stored. preflight
inspection is recommended.
TO REMOVE AND CLEAN THE FILTER:
1 . Remove the fuselage nose section grill.
2. Remove the wing nuts securing the filter and remove
the filter.
3. Clean as described in the manufacturer's instructions
on the filter.
PROPELLER BLADES
The daily preflight inspection should include a careful
examination of the propeller blades for nicks and
scratches.
Each blade leading edge should receive particular
attention. It is very important that all nicks and scratches
be smoothed out and polished. The BEECHCRAFT Aero or
Aviation Center and International Distributors or Dealers
will be glad to answer any questions concerning propeller
blade repair.
8-22
January 1982
To Next Page
Loading...