BEECH CRAFT Bonanza Section 111
V35, V35A & V35B thru D-9947 Emergency Procedures
If overvoltage condition persists:
2. Alternator Switch - OFF
3. Nonessential Electrical Equipment - OFF to conserve
battery power.
ENGINE INSTRUMENT MALFUNCTION
In event of engine instrument malfunction, maintain the
last known rpm and manifold pressure setting and pro-
ceed to the nearest suitable airfield and land. If a higher
power setting is required, select maximum rpm and en-
richen mixture appropriately.
CAUTION
At high altitudes and low power settings, full
rich mixtures may result in poor engine opera-
tion. Adjust the mixture for smooth engine op-
eration upon power reduction.
UNSCHEDULED ELECTRIC ELEVATOR TRIM
1. Airplane Attitude - MAINTAIN using elevator control.
2. Elevator Trim Thumb Switch (On Control Wheel) -
MOVE IN DIRECTION OPPOSITE UNSCHEDULED
PITCH TRIM to open circuit breaker.
3. Elevator Trim ON-OFF Switch (On Instrument Panel) -
OFF
4. Manual Elevator Trim Control Wheel - RETRIM AS
DESIRED.
NOTE
Do not attempt to operate the electric trim sys-
tem until the cause of the malfunction has
been determined and corrected.
January 1982
3-9
To Next Page
Loading...