Section Ill BEECHCRAFT Bonanza
Emergency Procedures V35, V35A & V35B thru D-9947
LANDING GEAR MANUAL EXTENSION
Manual extension of the landing gear can be facilitated by
first reducing airspeed. Then proceed as follows:
1. LOG GEAR Circuit Breaker - OFF (PULL OUT)
2. Landing Gear Switch Handle - DOWN position
3. Handcrank Handle Cover (at rear of front seats) -
REMOVE
4. Handcrank - ENGAGE and TURN COUNTERCLOCK-
WISE AS FAR AS POSSIBLE (approximately 50 turns)
CAUTION
The manual extension system is designed to
lower the landing gear only. DO NOT ATTEMPT
TO RETRACT THE GEAR MANUALLY.
5, If electrical system is operative, check landing gear
position lights and warning horn (check LOG GEAR
INDICATOR and LOG GEAR WARNING circuit breakers
engaged).
6. Check mechanical landing gear indicator - DOWN
(V35, V35A)
7. Handcrank - DISENGAGE. Always keep it stowed
when not in use.
3-10
WARNING
Do not operate the landing gear electrically
with the handcrank engaged, as damage to the
mechanism could occur. After emergency
landing gear extension, do not move any
landing gear controls or reset any switches or
circuit breakers until airplane is on jacks as
failure may have been in the gear up circuit
and gear might retract on the ground.
January 1982
To Next Page
Loading...