NORMAL PROCEDURES
PREFLIGHT
1. With engine operating, place propeller deice switch in
the ON position.
2. Check propeller deice system ammeter for reading of 20
to 24 amperes (2 blade), 30 to 34 amperes (3 blade).
IN FLIGHT
1 . Follow the placarded procedure to monitor electrical
load.
2. To place the system in operation, move propeller deice
switch to the ON position. The system will function auto-
matically until the switch is turned off.
CAUTION
The system is not to be operated continuously
due to its electrical load.
3. Propeller imbalance may be relieved by varying rpm.
Increase rpm briefly and return to desired setting, re-
peating if necessary.
PERFORMANCE • No Change
4of4
Approved: ~
7
4 Jc j//4
-~ y Chester A. Rembleske
Beech Aircraft Corporation
DOA CE-2
FAA Approved
Revised: November, 1977
PIN 35-590118-25
To Next Page