Beechcraft Baron 58 - Starting

BEECHCRAFT Baron 58
Serial TH 773 and After
Section IV
Normal Procedures
9. All Circuit Breakers, Switches and Equipment Controls
- CHECK
10. Battery and Alternator Switches
- ON (if external power
is to be used, Alternator Switches -
OFF)
11. Fuel Quantity Indicators - CHECK QUANTITY (See
LIMITATIONS for
take-off fuel)
12. Landing Gear Position Lights - CHECK
STARTING
1. Throttle Position - APPROXIMATELY 1 2 IN. OPEN
2. Propeller Control - LOW PITCH (high rpm)
3. Mixture Control - FULL RICH
NOTE
If
the engine is hot. and the ambient tempera-
ture is 90°F or above, place mixture control in
IDLE CUT-OFF, switch aux fuel pump to HIGH
for 30 to
60 seconds, then OFF. Return mixture
control to FULL RICH.
September, 1980