Bend-Tech Dragon mAchines - Torch & Cutting Troubleshooting; Cutting and Torch Troubleshooting; Copes are Not the Same Rotation; Y-Axis Backlash Needs Adjusting

26 Bend-Tech Dragon
Toolhead & Tools Troubleshooting
04
Troubleshooting Guide
04
Torch & Cutting
Troubleshooting
4.1 Cutting and Torch Troubleshooting
4.1.1 Copes are Not the Same Rotation
Material is not Properly Secured in the Chuck
Ensure material is tight in the Chuck. If using spacers for the material, ensure the
measurements are correct.
Settings in the Nesting Projects are not Correct
Check the part in Edit Flat.
Y-Axis Backlash Needs Adjusting
Remove the Trolley Cover and observe backlash on Y-Axis Motor. If incorrect adjust on
machine. See Section 6.8 for full procedure. Perform a Backlash Test in Machine Library >
Mechanical Settings.
Y-Axis Motor or Y-Axis Drive Gear Loose
Remove the Trolley Cover and perform visual and physical check of Y-Axis Motor and Y-Axis
Motor Drive Gear.
Y-Axis Motor Skipping Steps
Check Ethernet connectivity. Check to ensure Breakout Board is seated in Motor Drivers
properly. Ensure consistent power to machine.