Bend-Tech Dragon mAchines - Control Box Troubleshooting; Important; Motor is not Responding; Machine is not Powering On

42 Bend-Tech Dragon
Troubleshooting Guide
Control Box Troubleshooting
07
07
Control Box
Troubleshooting
7.1 Control Box Troubleshooting
Important

Bend-Tech service representative.
7.1.1 Motor is not Responding
Motor Driver has Failed
Replace the Motor Driver. See section 7.2.
7.1.2 Machine is not Powering On
Control Box Power Switch has Failed
Replace the Control Box Power Switch. See section 7.3.
7.1.3 Smooth-stepper is not Connecting to the Computer
Critical Failure in the Circuit Board or Circuit Board Component
Replace the Smooth-stepper Board. See section 7.4.
7.1.4 Axis is not Responding or is Responding Incorrectly
Breakout Board has come unseated from the Motor Drivers
Re-seat the Breakout Board. See section 7.6.