44 Bend-Tech Dragon
Troubleshooting Guide
Control Box Troubleshooting
07
5. Copy the Dip Switch Settings
Copy the dip switch settings on the old Motor Driver to
the new Motor Driver.
6. Install the New Motor Driver
Installation is the reverse of removal. During the
installation process, use the bottom mounting pin with
the nut still threaded onto it to seat the new Motor Driver.
7. Re-install the Breakout Board
Re-install the Breakout Board and close the Control Box.
7.3 Replacing the Control Box Power Switch
The Control Box Power Switch snaps into the power receptacle assembly.
1. Power o the Machine
2. Open the Control Box
counterclockwise.
3. Disconnect the Power Switch
Remove the two wires that connect to the Control Box Power Switch, noting the location of the
wires so they can be re-attached to the new switch in the same location.
4. Remove the Old Power Switch
5. Snap the New Switch into Position
Snap the new switch into its location.
6. Attached the wires to the New Switch
Swap the wires onto the new switch, ensuring the wires are attached in the same locations.
7. Close the Control Box
Close the Control Box.
Dip Switches
To Next Page
Loading...
Need help?
General
