Bender ISOMETER IRDH575 User Manual

115
IRDH575_D00089_05_M_XXEN/01.2020
D
Dimension diagram enclosure 110
Display in the menu mode
41
E
EDS4...
- Common message
28
- Max. test current, setting
60
- Start and stop conditions, setting -
auto, on, off, pos, 1cycle
58
- Type of the system, setting (DC/1AC/
3AC)
60
EDS46.../49...
- Adapting frequency converters to the
system being monitored (inverter)
66
- Assigning an EDS Alarm to one or
both common relays (Alarm
on/off)
67
- EDS test (test of all BMS bus nodes)
68
- Setting delay on response, T(off)
66
- Setting response values (ResVal)
66
- Setting the CT type (CT-W/WR)
66
- Setting the memory behaviour of an
EDS.
63
- Setting the nominal frequency
64
- Setting the operating mode of the 12
channel-related alarm relays
(Channel/Op.mode, only EDS490/
491)
67
- Setting the operating mode of the
common alarm relays alarm1 and
alarm 2 (Relay/op.mode)
67
- Setting the response delay, T(on)
66
- Setting the system coupling (DC/1
AC/3 AC)
64
- Starting the EDS with IRDH575 or
continuous EDS mode (Trigger)
63
- To enable or disable the CT monito-
ring (CT monitor)
66
EDS470/473
- CT Setup
73
- EDS monitor - indication of all de-
tected insulation faults
70
- Elongation of the measuring time
74
- Memory behaviour of EDS4...-12,
setting
73
- On or off switching of the CT monito-
ring
73
- Operating principle of the alarm re-
lays of EDS47..., setting
73
- Reset
70
- Test of all BMS bus nodes
70
Essential functions, ISOMETER
17
External coupling devices
55
External RESET button
32
External TEST button
32
F
Factory settings 89
Fault messages, language setting
78
Flashing point
83
Function
19
Function input F1/F2
22

Bender ISOMETER IRDH575 Specifications

General

Brand	Bender
Model	ISOMETER IRDH575
Category	Measuring Instruments
Language	English