Safety instructions
11
NGRM7xx_D00292_07_M_XXEN/02.2022
2. Safety instructions
2.1 General safety instructions
Part of the device documentation in addition to this manual is the enclosed "Safety in-
structions for Bender products".
2.2 Work activities on electrical installations
If the device is used outside the Federal Republic of Germany, the applicable local
standards and regulations must be complied with. The European standard EN 50110
can be used as a guide.
Only qualified personnel are permitted to carry out the work necessary to
install, commission and run a device or system.
Risk of electrocution due to electric shock!
Touching live parts of the system carries the risk of:
An electric shock
Damage to the electrical installation
Destruction of the device
Before installing and connecting the device, make sure that the
installation has been de-energised. Observe the rules for working on
electrical installations.
To Next Page
Loading...
